Hello. The relay module controls the 220V fluorescent lamp in Arduino. It has been confirmed that the lamp also operates whenever the relay module is switched on and off. But I want to put in a fuse holder because I want to control it while preventing overcurrent more safely, Is it okay to connect the circuit like this?? I'm currently using an Arduino unit3 compatible board. Below is the code used. void setup() { // put your setup code here, to run once: pinMode(9, OUTPUT); } void
Safety concerns about generic Arduino relay modules - Project Guidance - Arduino Forum
Switch hookup with relay (arduino)
Safely using a relay - General Electronics - Arduino Forum
I have a relay board but I dont know if it has optocoupler built in? - Motors, Mechanics, Power and CNC - Arduino Forum
Activate a 220VAC solenoid valve via opto isolated relay - Motors, Mechanics, Power and CNC - Arduino Forum
Arduino UNO, 8 channel relay board and 220v spark generator - General Electronics - Arduino Forum
Relay for arduino - Motors, Mechanics, Power and CNC - Arduino Forum
220V Switch Controller with a triac - Hardware - Arduino Forum
Safety check of 230V relay project - General Electronics - Arduino Forum
What relay can be used to run a 220V current with an Arduino without using any transistors? - Quora
Arduino UNO, 8 channel relay board and 220v spark generator - General Electronics - Arduino Forum
Controlling AC Light Using Arduino With Relay Module : 7 Steps - Instructables
What relay can be used to run a 220V current with an Arduino without using any transistors? - Quora
Relay Module stops working mid cycle - General Electronics - Arduino Forum
